Heater with tip over protection

Fri, 22 May 2026 17:15:02 +0800

We built this heater for the messy, real-world reality of industrial floors—where things get bumped, knocked, and jostled. So we baked tip-over protection straight into the design. If the whole unit gets knocked off its mount, the heating element shuts down instantly. No runaway heat. Just peace of mind for your equipment and your people. Here’s the technical bit, straight and simple: it runs on 400V, the same voltage you already have in most industrial lines. That keeps the current manageable and the wiring clean. You get 2500W of power across a 300mm length, so it hits operating temperature fast. But that kind of heat density means one thing: the machine needs room to breathe. Make sure airflow is there. Otherwise, the control electronics will cook themselves. Inside, the heating element is a halogen lamp housed in a quartz tube, with a reflective coating that pushes infrared energy forward in a tight beam. That coating doesn’t just boost directional heat—it also shields the filament from dust and other airborne grit. And when it’s time to swap something out, the R7s connector is a straight-in, plug-and-play fit. Wire it up, clamp it in, and you’re back on the line without wrestling with the mounting bracket. Take PET blowing, for example. You need intense, focused heat right on target—no scorching the frame around it. The built-in tip-over safety is a hard stop: if the assembly shifts even a bit, power cuts immediately. That keeps your process humming and cuts the risk of burnouts. For you, it means fewer surprise stops. A heater that can take the heat, and the occasional knock, without breaking stride.

Tip on Pure Quartz Infrared Heaters

Heater with tip over protection